Connecting automation process steps

To allow an automation process to move from one step to another, you need to connect the steps. Each step has one or more source points, which you can drag to another step to create a connection.

Working with source points

The red points next to steps are source points.

Connecting steps by dragging a source point

Certain types of steps have multiple source points.

A step with multiple source points

For example, a Condition step branches the process into two paths, so it has two source points. You can use the condition step to branch the process into an if/else condition using its two source points. The process continues through the blue source point if the condition is met. The red point indicates the branch used when the condition is false.

Steps that offer multiple conditions have multiple blue source points, one for each condition.

On this page

Kentico EMS required

Features described on this page require the Kentico EMS license.

Creating connections between steps

You can drag source points on top of other steps to create a connection between the two steps.

  1. Place the steps you want to connect onto the grid.
  2. Click the source point of the step you want the connection to lead from and hold the mouse button.
  3. Drag the source point over the step you want to connect.
    • Moving a source point on top of a target step highlights it in the designer.
  4. Release the mouse button.

After you create the connection, it stays selected. You can immediately change the connection by dragging again or remove it by pressing the Delete key.

Newly created connections remain highlighted

Changing connections

  1. Click the connection that you want to change and hold the mouse button.
  2. Drag the connection to the new target step.
  3. Release the mouse button.

This removes the original connection and creates a connection with the new target step instead.

Changing existing connections

Deleting connections

  1. Click the connection to select it.
    • The connection changes its color and increases in thickness.
  2. Press the Delete key.
  3. Click OK in the confirmation box.

Deleting a connection resets the source point to its default position.


Was this page helpful?